![]() Let Bilotto show you exactly how it's done, below. Ten days later, take the lights off and put up a sign that this was the national Christmas tree in that year. You'll get a festive look and more time to celebrate. You'll also get a brighter effect, because the lights stay at the tips of the branches instead of sinking in toward the trunk. ![]() Once you've reached the bottom branches, start weaving your way back up.Įfficiency isn't the only advantage of using this lighting method. Simply start by placing the non-plug end of your string lights at the top of the tree and weave the cord down through the tree's branches. It turns out, there's a much easier way to get your tree lit that doesn't require you to walk in circles around the tree until your head spins.ĭesigner Francesco Bilotto showed that hanging lights vertically on your Christmas tree is much easier than the traditional way. After an emergency trip to the hardware store to pick up more, you then have to string the lights on the tree, which inevitably takes longer than expected. It seems like every year when you pull your lights out of storage, half of them don't turn on. ![]() I don’t own any special tools, so the solution isn’t very elegant, but by going through the light strand and replacing all of the bad bulbs, I eventually hit on the one (or two) bulbs that were causing the whole strand to fail.Perhaps one of the biggest headaches of the holiday season is dealing with Christmas tree lights. If you have a problem with a set of three-wire Christmas lights that aren’t working, I hope this solution is helpful. It seemed like a lot of work initially, but I found the problem bulbs in less than twenty minutes. The keys for me were (a) knowing that the bulbs could be in one of those three states, and (b) just taking the time to test and replace all the bad bulbs until the strand started working again. I assume this bulb was paired with the first bulb in the strand that was out, but I have no way of knowing that for sure. I replaced about four bulbs until I replaced one light bulb and the entire strand came to life. The bulb didn’t work, and it caused the rest of the light strand to fail.The bulb didn’t work, but the rest of the light strand worked. ![]() We found several bulbs that were in one of three states: We didn’t have any special tools for this, so what we did was just start at the first bulb that wasn’t working, and then we tested every other bulb in the strand after it by removing it and testing it with another strand. Once we replaced both bulbs, the entire light strand lit up. For us, the “pair” part was a key, and through a little trial and error, we found out that the bulb where the light strand stopped working had indeed burned out, but it was also joined up with a second bulb further down the line that had also gone out. The short version of that article is that the way these light strands work is that the light bulbs are connected in series and in parallel, and the most important thing to know is that the bulbs seem to be connected in pairs. We couldn’t fix it by replacing the bulb right where the light string stopped working, so I looked into it and found this helpful (but a little too technical) article. Yesterday we had a three-wire Christmas light string where the first half of the string was working, but the second half of the light string wasn’t working.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |